8

1050 Chapter 14: Character Studio
Set Parameters from Animation group
Usethisfunctiontoobtainmotionparameters
from an animated object and apply them to all
specified delegates. It affects only Average Speed,
Max Accel, and the Turning parameters.
Because this one animation w ill set most of
the parameters of the delegate, it should be
representative of a whole range of motion of the
delegate. For example, the object should turn and
accelerate. The animation should be somewhat
lengthy so that averages are calculated correctly.
Animated Object—Specifies an animated object.
Click this button, and then choose the object from
the list in the Selec t dialog.
Set—After specifying the animated object, click
this button to apply its par a meters to the delegate
settings. Also turns on the SET check box for any
affected parameters.
General group
Rather than numeric values, the settings in this
group are on-off switches, except for the first,
Velocity Color. To change Velocity Color, click the
colorswatch,usetheColorSelectordialogtopick
a new color, and then turn on the Velocity Color
SET check box. To change an y other setting in the
General group, click the check box to the right
of the setting, and then turn on the setting’s SET
check box.
Thesesettingsarethesameasthosefoundinthe
delegate object’s
Motion P arameters rollout (page
2–1035)
.
Speed group
These parameters are the same as those found in
thedelegateobject’s
Motion Parameters rollout
(page 2–1035)
. For an explanation of the Random
and SET check boxes, see the introduct ion to this
topic.
Turning group
These parameters are the same as those found in
thedelegateobject’s
Motion Parameters rollout
(page 2–1035)
. For an explanation of the Random
and SET check boxes, see the introduction to this
topic.
Bankin g group
These parameters are the same as those found in
thedelegateobject’s
Motion Parameters rollout
(page 2–1035)
. For an explanation of the Random
and SET check boxes, see the introduction to this
topic.
Biped group
These parameters are the same as those found in
thedelegateobject’s
Motion Parameters rollout
(page 2–1035)
. For an explanation of the Random
and SET check boxes, see the introduction to this
topic.
Stor ed D ial og S etti ngs—Use this list to specify
up to 10 different combinations of delegates and
settings. To store a combination, cho ose a name
from the list, and then specify the delegates and
settings. To recall a combination, choose its name
from the list. To rename a combination, choose its
name from the list, and then highlight the name
andedititusingthekeyboard.
Che ck A ll S e t s—ClickthisbuttontoturnonallSET
check b oxes. This ensures that any changes you
makeinthedialogtakeeffectwhenyouclickthe
Apply Edit button.
Apply Edi t—Click Apply Edit to implement all
changed settings and exit the dialog.
Clo se —Click Close to remember, but not
implement, all changed settings and exit the
dialog.
Can cel—Click Cancel to forget all changed settings
and exit the dialog.