Datasheet

51
Tutorial 2 — Create a
Birdhouse Drawing
In this tutorial, you learn how to use AutoSketch
®
to
create a birdhouse drawing. You create a single entity
from scratch, and you create an entity by grouping and
rubber-stamping an existing entity. You also add
dimensions and a title, and then place them on the
appropriate layers. Finally, you print the drawing.
More information about each of the concepts in this
tutorial is available in the Help system.
In this tutorial
■ Introduction
■ Set Up the Birdhouse Drawing
■ Create the Floor of the
Birdhouse
■ Add Dimensions to the Floor of
the Birdhouse
■ Add a Title to the Floor of the
Birdhouse
■ Create the Back of the
Birdhouse by Grouping and
Rubber-Stamping
■ Add Dimensions to the Back
■ Add a Title to the Back
■ Print the Completed Birdhouse
Drawing