Datasheet

Trim an Entity | 47
First, join two perpendicular lines to create an intersection.
4 On the All-In-One toolbar, click Trim Corner.
5 In the Trim Corner 1 section of the drawing, click the horizontal line.
Then, click the vertical line to the right of that horizontal line. Right-click
to end the command.
Example of two perpendicular lines joining to form a corner
Next, use the same Trim Corner button to remove excess lines and form a
corner.
6 On the All-In-One toolbar, click Trim Corner.
7 In the Trim Corner 2 section of the drawing, click the left side of the hor-
izontal line. Then, click the lower part of the vertical line. Right-click to
end the command.
Trim Corner 1 Trim Corner 2 Trim Round
Trim Bevel Trim Edge Trim Break
first selection second selection result