Datasheet

44 | Tutorial 1 — Create and Trim Entities
Now, use the All-In-One toolbar to create a different kind of arc.
3 On the All-In-One toolbar, click and hold the Arc button.
4 On the toolset, drag the pointer until you locate 2 Points and Center, and
then release the mouse button.
5 In the drawing window, click a point to begin the arc. Click another point
to mark the second point. Then, click again to mark the centerpoint.
Example of an arc produced with the 2 Points and Center option
Tip The status bar, in the lower-left corner of the drawing window, displays
prompts that describe the next step in a procedure. If you’re unsure what the
next step is, look at the status bar for prompts.
6 When you finish working with arcs, delete the entities.
To create a circle
1 On the Draw menu, click Circle ➤ Center, Side.
2 In the drawing window, click a point to set the center of the circle, and
then drag the pointer out from the center until the circle is the size you
want. Then, click at that point to complete the circle. Try this a few times
to get familiar with it.
Example of a circle produced with the Center, Side option
Click startpoint Click second point Click centerpoint
Click a point Drag pointer
outward
Click to complete
circle