Manual

WINCUE USER GUIDE APPENDIX B







AUTOCUE LTD. 2002

B4 SCSI ID - SW2

By default, SCSI ID is set to 3. It can be changed using dipswitches 1,2 and

3 on SW2.

When a dipswitch is in the top position it is on. When it is in the bottom

position it is off. The dipswitch positions for each SCSI ID is shown in the

table below:

Dip Switches

SCSI ID

1 2 3

0 On On On

1 On On Off

2 On Off On

3 On Off Off

4 Off On On

5 Off On Off

6 Off Off On

7 Off Off Off

B4 SCSI/Parallel Select - SW2

The I.M.T. card can prompt using data sent through either the SCSI port or

parallel port of your PC. By Default it is set up to use SCSI. Dip switches 4

on SW2 controls whether the SCSI or parallel port is used.