Manual

WINCUEPRONEWS USER GUIDE
VERSION 1.30B515 115  QTV 1998
Centre Stop Mode is used if the operator does not wish to use the FWD/REV button to
change the direction of the prompted text. To enable the C
entre Stop Mode, the check box
should be checked (). Next the S
top Point and Stop Zone should be set.
7.5.2 Configuring Scroll Control Buttons
The Buttons tab allows the user to configure each of the buttons individually. This means the
multi-button scroll control can be customised to suit a particular application.
These buttons are pre-configured for use. The standard settings are as shown overleaf.