User Manual

WINCUEPRO FOR AVSTAR USER GUIDE APPENDIX D
VERSION 1.30 109  QTV 2001
The device name can be set to the previously configured device or, if there is only
one stand, it can be left as (Any device). Specify which stand will be controlled in
a multiple stand setup (this can be left as Stand 1 in a single stand setup).
Choose the new height for the stand and any comment that should appear next to
this control in the script. Click on OK and the control will appear in the script
where the cursor was.
This control can be double-clicked on to change the settings entered above.
NOTE: Before prompting the script the device must be activated so that WinCue
can control it. This is done by choosing D
evices from the Automation menu and
selecting the previously named device.