User Guide User guide

Appendix B: Wireless Operation

Configure QBox for wireless peer-to-peer connection

QBox

Installation & Operation

Guide

www.autocue-qtv.com

5. Use the arrow keys on the keyboard to select wlan0 and press Enter to display the

tabs containing controls for setting the wireless network parameters.

6. Press the Tab key to highlight Ad-Hoc (peer-to-peer) Mode and press the Space

bar on the keyboard.

7. Press the Tab key and enter the ESSID of your WiFi network. Contact your IT

department to obtain the necessary information for your network.

8. Hold down the Ctrl key and press the Page Down key to open the WiFi Security

tab.

9. Press the Tab key and highlight the WEP option and press the Space bar on the

keyboard.

10.Press the Tab key until the WEP Key field is highlighted and enter the required key.

This is usually a string of 26 alphanumeric characters.

NOTE: Take care when entering the key as you must enter the same key for any

device that will be connected to the QBox.

11.Press the Ctrl and Page Down keys to select the IPv4 Settings tab.