Owner's manual

www.qtv.com

www.autocue.com

Section 6: MSP20 Operation

OSD controls

Accessing the OSD controls

MSP20

Assembly and Installation

Guide

6.2.1: Accessing the OSD controls

The Menu button on the side of the MSP20 opens the OSD controls. An example

OSD menu screen is shown below.

NOTE: If no adjustment is made to a control, the OSD will switch off

after approximately ten seconds

There are six main OSD menus that are used to set up a MSP20 prompter display

unit:

• Input Select

• VGA Adjustments

• Color adjustments

• Video settings

• Scaling adjustments

• System Settings

The tables in the following sections list the various sub-menu selections and the

options that can be set for them.

Press the Up and Down arrows to highlight a heading and press the Menu button

to select it. The sub-menus within the six main categories are selected with the Up

& Down buttons.

Press Menu again to select a sub-menu from a category and then the Up and Down

arrows to adjust or change the parameters. Press Menu once more to save the

setting.