Manual

9
4.2. OSD MENU Adjustments and Settings
The following table shows all adjustment and setting menus.
Main Menu Sub Menu Reference
Input
Main Input Source Selection:
VGA/DVI/S-video/CVBS/SDI
Brightness
Digital brightness setting ：
(Value: 0 – 100)
Contrast
Digital contrast setting ：(Value: 0 – 100)
Sharpness
Set Sharpness：(0-24)
Aspect Ratio
Picture scaling mode：
(5:4/ 4:3/Full /Full Aspect/ Native/ User)
Image
Mode Select According to Mode Selection
Color temp
Color Temp Setting：
5500K, 6500K, 7500K, 8500K, 9300K,
10000K, USER
Gamma 3.0, 2.8, 2.6, 2.4, 2.2, 2.0, 1.8
OSD Position
Adjust the location of the OSD menu：
(Center/Top Left/Top Right Bottom Left/Botto
m
ig
ht)
OSD Language
Select language of the OSD menu ：(English/
中文)
Auto Scan Input The monitor would auto scan video source or
not : (On /off)
Setup
Factory Reset
Recall the default value
Auto Adjust Automatically Adjust the picture
H-position Set the horizontal position
V-position Set the vertical position
Clock According to the pattern choice
VGA
Phase
According to the pattern choice
FW version Information about the version of software
Main Input Information about the current Main video
source
Status
Main Format
Information about the current Main timing
4.3. Screen Adjustment
Screen adjustments for the LCD monitor should be used in suppressing screen
flickering and also for adjusting the screen to its proper position. There is only one
correct position for each display mode. It is also recommended to use the OSD Menu
function when first installing the display or whenever changing the system.
Note: Allow the LCD monitor to stabilize for at least 20 minutes before making image
adjustments. Making Adjusting must be VGA signal.
Making adjustment must be VGA signal.