Specifications

equipment details
170
equipment details
171
tempo bed make up
SINGLE BEDS
1. Slide passenger seat forward with
passenger seat facing front
2. Fully depress lever on side of seat (fig 1)
3. Pull seat base forwards to allow back rest
to be lowered into position (fig 2&3)
4. Fit infill cushion between end of bed and
cab seat
DOUBLE BED
1. Make up single bed as described above
2. Depress lever on front of bench seat
3. Pull out slatted bed base and cushion
4. Turnbackrestthrough180ºandplace
into position.
Fig. 1
Fig. 2
Fig. 3
Coaxial Plugs
It is critical that all coaxial plugs in the system
are fitted correctly. Using the diagram and
procedure described, please check each
individual plug, ensuring it is wired correctly.
Secondly please ensure only quality plugs have
been used.
Coaxial Cable
Sharp bends, kinks and hot surfaces can
easily damage coaxial cable and should be
avoided. An inspection of the cable routing
is recommended to ensure all is correct
Coaxial cable, if placed in close proximity
to electrical cables, transformers or other
pieces of electrical equipment, may pick up
electrical interference causing picture quality to
deteriorate, especially in poor reception areas.
ExcesscableshouldberemovedandNOT
coiled as this may cause picture distortion.
Pinnacle
The pinnacle is essential for the optimum
performance of the antenna and therefore
should be in place when the antenna is in use.
Gain Switch
Situated below the LED light on the Power
Pack, this switch should be set to the normal
‘NMl’(switchUP)positionforgeneraluse.The
Low setting may be used when situated close
toTVtransmitterswherestrongsignalsmay
be affecting the quality of the picture. (see
Interference 2 below)
Red LED light
Should the red LED on the Power Pack not
light, first try unplugging the cable connected
totheAntennaDomefromthe‘ANT-IN’socket
If the LED then illuminates the fault lies with
either the coaxial plug or the coaxial cable,
please refer to these areas described earlier.
If the LED is still not lit, please contact our
office for further assistance.
Short Hook Up Test
This test isolates parts of your system leaving
onlytheTVandtheStatusantennalinked
directly together. Firstly, unplug the coaxial
plugsfromthe‘TV-FM’socketsofthePower
PackwhichwillbeconnectedtoaTVoutlet
socket.WithyourTVylead,connectyourTV
direct to the Power Pack, plugging into one of
the‘TV-FM’sockets.
Ensure the antenna dome is plugged directly
intothe‘ANT-IN’socketofthePowerPackand
switchon.TuneinyourTVforthestrongest
signal. If the picture quality is improved the fault
lies with the wiring of the system between the
PowerPackandtheTVoutletsocket
Antenna Dome Coaxial Cable
Check the routing of the coaxial cable from the
Antenna Dome to the Power Pack. Check to
ensure there are no kinks or trapped cable or if
there are loops of surplus cable which could be
affecting performance.
When the Antenna Dome was originally fitted
and lowered onto the Mounting Foot, cable
may have been trapped or kinked under the
Mounting Foot To check, remove the Antenna
Dome as described to see if this has occurred.