Specifications

equipment details
96
equipment details
97
As standard, Truma supplies a suitable cover
frame, in agate grey colour, for every control
panel/every time switch. In addition, cover
frames are also available as special accessories
in the colours black, beige, platinum or gold.
Suitable for control panels or time switches,
the side pieces available in eight different
colours create a visually attractive finish.
Please contact your specialist dealer in
this connection.
Clip row (part no. 34000-65900). For installing
several Truma control panels next to one
another.
MANUFACTURER’S TERMS OF WARRANTY
1. Case of warranty
The manufacturer grants a warranty for
malfunctions in the appliance which are based
on material or production faults. In addition to
this, the statutory warranty claims against the
seller remain valid.
A claim under warranty shall not pertain:
– for parts subject to wear and in cases of
natural wear and tear,
– as a result of using components in the
units that are not original Truma parts and
using unsuitable gas pressure regulators,
– as a consequence of failure to respect
Truma instructions for installation and use,
– as a consequence of improper handling,
– as a consequence of improper transport
packing, not arranged by Truma.
2. Scope of warranty
The warranty is valid for malfunctions as stated
under item 1, which occur within 24 months
after conclusion of the purchase agreement
between the seller and the final consumer. The
manufacturers will make good such defects by
subsequent fulfilment, i.e. at their discretion
either by repair or replacement. In the event
of manufacturers providing service under
warranty, the term of the warranty shall not
recommence anew with regard to the repaired
or replaced parts; rather, the old warranty
period shall continue to run. More extensive
claims, in particular claims for compensatory
damages by purchasers or third parties, shall
be excluded. This does not affect the rules of
the product liability law.
The manufacturer shall bear the cost of
employing the Truma customer service for
the removal of a malfunction under warranty
– in particular transportation costs, travelling
expenses, job and material costs, as long as the
serviceiscarriedoutinGermany.Thewarranty
does not cover customer service work in
other countries.
Additional costs based on complicated removal
and installation conditions of the appliance
(e.g. removal of furniture or parts of the
vehicle body) do not come under warranty.
3. Raising the case of warranty
The manufacturer‘s address is:
TrumaGerätetechnik
GmbH&Co.KG,
Wernher-von-Braun Strasse 12,
85640 Putzbrunn.
InGermany,alwaysnotifytheTrumaService
Centre if problems are encountered; in other
countries the relevant service partners should
be contacted (see Truma Service Booklet or
www.truma.com). Any complaints are to be
described in detail. In addition, the properly
completed guarantee certificate is to be
presented, or the factory number of the unit
and the date of purchase given.
In order for the manufacturers to be able
to determine whether an incident subject
to guarantee has occurred, the end user
must, at his own risk, bring the device to the
manufacturers or send to them. If there is
damage to heaters (heat exchangers), the gas
pressure regulator must also be sent back to
the factory.
In instances of the device being sent to the
works, dispatch is to be effected by freight
transport. In cases under guarantee, the works
shall bear the transport costs or the costs of
delivery and return. If the damage is deemed
not to be a warranty case, the manufacturer
shall notify the customer and shall specify
repair costs which shall not be borne by the
manufacturer; in this case, the customer shall
also bear the shipping costs.
truma warranty