Instruction manual

4
USING PART 2221 - REMOTE LEAD HOUSING
Recommended to be used when you bike power a Logic system.
Position Part 2217 or 2218 into the remote housing as shown in picture K.
Set the mode selector switch to mode 2 or 3 (as shown on page 3, pictures F, G and H).
Connect end A of the remote lead to the main PCB in the housing (picture L).
Position the lead into the grommet and fit the lid and four screws, after making sure that the gasket
(picture M) is fitted correctly. The finished remote module should look as per picture N.
Open the Logic as in the instructions on page 2 and connect end B of the remote lead as shown in picture
O, fit the raised profile lid per the instructions on page 3.
K
O
N
M
L
End A
End B
Gasket
Remote Extension for Logic Systems
Bluetooth Modules Manual v4 29/6/09 10:55 am Page 4