Instruction manual

3
Setting the MODE selector switch
Set the mode selector switch to Mode 2
(pictures F and G) to make the audio affect
other inputs as Aux 2 does.
Set the mode selector switch to Mode 3
(pictures F and H)to make the audio affect other
inputs as Aux 3 does, this is the standard factory
setting.
After setting the mode selector switch, fit the new
raised profile lid taking care to first align the front
panel into the side slots (as per picture I) and
make sure the new lid fits evenly and snug around
the front panel and back cover area. Check that
the printed circuit board (PCB) and battery tray
are sitting correctly, then fit the two new long
fixing screws.
Replace the power lead or batteries and then
the battery cover.
TURN TO PAGE 7 FOR PAIRING INSTRUCTIONS.
G
H
I
J
Mode 2
Mode 3
Side slots
F
Mode selector switch
AUT01
Mode selector switch
AUT02
Picture shown with Twin module fitted
Bluetooth Modules Manual v4 29/6/09 10:55 am Page 3