Instruction manual

Fitting the Bluetooth Module
Unplug the headsets from the control unit,
remove the battery cover and the batteries or bike
power lead. (Picture A).
Turn the control hub over and lay it on a clean dry
cloth with the label side up, peel the label off and
remove the two screws. (Picture B).
Carefully remove the cover by using your left
hand to hold the front panel/cables down while
using your right hand to lift the top cover off,
which exposes the main printed circuit board and
you will see the two black 8-pin connectors (Logic
picture C), or single 8-pin connector (Logic
Independence Wireless picture D).
Carefully align the Bluetooth module (per picture
E) making sure that the radius cut-outs line up
with the fixing posts and take special care to
align all the 8 or 16 pins before pressing together.
STEREO BLUETOOTH INTERNAL MODULES
PARTS 2217 AND 2218
2
A
B
D
E
C
Logic system with 2 black 8 pin connectors Logic Independence Wireless system with 1 black 8 pin connector
Radius cuts and fixing posts
Picture shown with Single module fitted
Internal Modules for Logic Systems
Bluetooth Modules Manual v4 29/6/09 10:55 am Page 2