Instruction manual
16
The output level pre-set adjustment controls (by each audio Aux connection) affects the audio
output level for that Aux connection.
All audio input levels are controlled by the audio devices own volume controls.
Servicing the headset/power leads; as you can see from the above photograph these leads can be
unplugged from the main control box and so servicing is easy should you ever damage these leads. If
you prefer to swap the rider and passenger headset leads over you can do this but please always
position the riders lead in the front panel slot that lines up with the rider identification mark on the lid,
as the riders headset with ambient noise sensor must be plugged into the lead that connects to the
rider socket inside the main control unit.
Bike-to-bike interface leads; the colours of the wires attached to the white connector may vary.
Passenger’s Headset
Lead and Connector
12 Volt Power Lead
and Connector
Optional Bike-to-
bike Interface Lead -
Connection - Aux 1
Rider’s Headset Lead
and Connector
Aux 2 pre-set audio
output level control
Aux 4 pre-set audio
output level control
VOX Sensitivity
Control
Aux 3 pre-set audio output level control
INTERNAL CONNECTIONS/SETTINGS/ADJUSTMENTS
Please note; all adjusters are shown as set to factory settings which suit most user’s preferences. It is
recommended that you consult your dealer before attempting to adjust these internal adjustments.
Lower
Higher
Lower
Higher
Rider’s
Volume
Control
Passenger’s
Volume
Control
Logic Instructions 8/5/09 3:28 pm Page 16