Instruction manual

To Charge the Battery
1. Plugthemainswallchargerleadintothe2mmpowersocketontheairunit(8)+
2. The display will show a RED LED while charging and will automatically change to trickle
 chargeuponcompletionandtheREDLEDwillextinguish.++
3. Standardbatterychargetime3hours.+++
+ NeverconnectthechargerifthebatteryisnotconnectedtotheAirunit.
++ Ifabatteryhasnotbeenchargedforalongtime,thechargingsystemmaynotstartimmediately.The
 Airwillregeneratethebatteryandthechargingcontrollightwillashuntilthebatteryisconditioned.
+++ Neverwearthehelmetwhenchargingthebattery.
+++ Thechargershouldbeswitchedoffandthebatterydisconnectedimmediatelyifanycomponentgetshot.
Autocom Air Operation
To Switch-on and Switch-off
1. SwitchOn-HolddowntheMultifunctionButton(5)untilyouhearabeep.
2. SwitchOff-HolddowntheMultifunctionButton(5)untilyouhearabeep,andaREDLEDis
momentarily seen on the unit.
Pairing to a Mobile Device
*Before installing/using your Autocom Air it is recommended that you pair it with your Bluetooth devices.
1. StartwiththeAirunitswitched-offandturnoffallotherBluetoothdevicesnotneededforthe
pairing.