Specifications

20 www.auto-trail.co.uk
EC100 Control Panel
: Owner’s Handbook
The voltage display can be viewed continually by
pressing and holding the button until you hear a
long beep. To cancel the permanent display press
and hold the button again.
The LED next to the button indicates which battery
is selected. This LED will show green if the battery
is being charged, and red if the battery is
being discharged.
Fresh Water Level
This switch is used to measure the level of the water
in the fresh water tank.
Press once to select the fresh water tank and to
show the water level.
The tank has 5 levels;
• Empty
• 1/4
• 1/2
• 3/4
• Full.
The display will turn off automatically after ten
seconds. If you would like the water level displayed
permanently press and hold the button until you
hear a long beep. To cancel the display press and
hold this button again.
If the water pump is turned on and the water level
drops below 1/4 a warning beep will be heard and
the LED will flash. To cancel press and hold the
water level button.
If the pump is turned off and the water level drops
below 1/4 the LED next to the button will show red
to indicate that the tank is almost empty.
Waste Water Level
This switch is used to measure the level of the water
in the waste water tank.
Press once to select the waste water tank and to
show the water level. The tank has only two levels,
empty or full.
The display will turn off after ten seconds. If you
would like the water level displayed permanently
press and hold the button until you hear a long
beep. To cancel the display press and hold this
button again.
If the water pump is turned on and the waste water
level rises to full a warning beep will be heard and
the LED will flash. To cancel press and hold the
water level button.
If the pump is turned off and the waste water level
rises to full the LED next to the button will show
red to indicate that the tank is almost empty.
.
2090 AT Apache-Tracker Owners Handbook REPRO 2:Layout 1 18/11/08 14:35 Page 20