Specifications

TAKE YOURS ON AN ADVENTURE
19
EC100 Control Panel
EC100 Control Panel
The LED control panel (normally located over
the entrance door) controls all of the on board
12V systems.
Basic Controls On The Panel
Power ON / OFF
Use this switch to turn the main 12V power on
and off in the vehicle (press once and LED will
illuminate indicating power on, press again,
LED will go out indicating power off).
When the power is turned on the Leisure battery
is automatically selected and the LED will show
the battery voltage.
The power on LED shows green under normal
conditions, but if the PSU overheats or
develops a fault it will show red.
Pump ON / OFF
Use to turn the on board water pump on and off
(LED next to switch will illuminate when pump
is switched ON).
We would always recommend that the pump
is switched off when leaving the motorhome
for any period of time.
Aux ON / OFF
On all auto trail vehicles the Auxiliary switch is
used to turn on and off the exterior awning light.
Pressing the button once switches the light on
(LED will illuminate) pressing it again will switch
the light off (LED goes out).
Leisure Battery Select & Voltage Display
This switch is used to select the leisure battery
and to display the battery voltage level.
Press button once to select and display the
voltage. The display will turn off after ten
seconds.
The voltage display can be viewed continually
by pressing and holding the button until you
hear a long beep. To cancel the permanent
display press and hold the button again.
The LED next to the button indicates which
battery is selected. This LED will show green
if the battery is being charged, and red if the
battery is being discharged.
Vehicle Battery Select & Voltage Display
This switch is used to select the vehicle battery
and to display the battery voltage level.
Press button once to select and display the
voltage. The display will turn off after ten
seconds.
2090 AT Apache-Tracker Owners Handbook REPRO 2:Layout 1 18/11/08 14:35 Page 19