RF-501 OPERATION INSTRUCTIONS
!!NOTICE!! THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. FEDERAL COMMUNICATION COMMISSION RULES AND REGULATIONS PROHIBIT THE ADJUSTMENT OF THE TRANSMITTER PORTION OF THIS SYSTEM BY UNLICENSED PERSONNEL.
CONGRATULATIONS on your purcahse of the RF-301 vehicle security system. AutoPage, Inc. is one of the companies in the United States with the longest history and experience in vehicle security, and a wholly owned subsidiary of Iwata Electric Co., of Tokyo, Japan. Iwata has been an industry leader for 40 years, establishing a reputation for ingenuity in its engineering capability and innovative cxommunication products.
RF-501 OPERATION INSTRUCTIONS A. TRANSMITTER OPERATION 1. ARM/DISARM TO ARM THE RF-501 Press the GREEN button once to arm. The siren will chirp one (1) time, the lights will flash, and all doors will lock. TO DISARM THE RF-501 Press the green button once to disarm. The siren will chirp two (2) times, the lights will flash, and all doors will unlock. If optional dome light supervision has been installed, all lighting normally connected to the vehicle's pin switches will turn on for 60 seconds.
3. DELETING THE PRE-WARNING SENSOR CIRCUIT (IF INSTALLED) The RF-501 offers an option to pre-warn possible violators with siren chirps before triggering the alarm. The alarm will trigger on the third violation within 15 seconds. To delete the pre-warning sensor, press the GREEN button again within 5 seconds after arming. The siren will confirm deletion with a low chirp. NOTE: Deleted sensor(s) will return to normal operation upon disarming the RF-501.
the usual manner. The chirp signal will be silenced only for this particular operation. The sequence must be repeated each time if it is desired to cancel the arm/disarm chirp signal. 2. Upon deleting the arm/disarm chirp signal, arm/disarm verification may be made by watching the vehicle's lights flash. 5. TRUNK/HATCH RELEASE To remotely release the electric trunk or hatch on the vehicle you must first disarm the RF-501. After disarming push the BLACK button on the transmitter for THREE (3) seconds.
and disarms the alarm. B. LED STATUS INDICATOR OPERATION 1. 2. 3. 4. 5. LED OFF= The RF-501 is disarmed or in the valet mode. LED CONSTANT ON= Indicates open trigger circuit. LED FAST FLASHING= Passive arming timer is counting down. LED FLASHING= The RF-501 is armed. LED FLASHING IN A 2 FLASH/HOLD SEQUENCE= Alarm breach. C. AUDIBLE AND VISUAL ALARM STATUS INDICATOR 1. 1 CHIRP WITH LIGHT FLASH= Alarm is armed. 2. 2 CHIRPS WITH LIGHT FLASH= Alarm is disarmed. 3.
The RF-501 may be placed into the VALET (stand-by) mode to allow for vehicle service, car washing, or attendant parking without self arming after the ignition is switched off, and without leaving the RF-501 transmitter with unauthorized individuals. To enter the VALET mode, the vehicle ignition must be in the "ON" position; then move the VALET/OVERRIDE SWITCH to "ON". To return to normal operation, the vehicle ignition must be in the "ON" position; then move the VALET/OVERRIDE SWITCH to OFF.
NOTE: If the optional relays have been installed to control the vehicle power door locks, the locks will automatically lock ten (10) seconds after the PASSIVE arming cycle is completed. If remote door lock/unlock is installed and automatic locking in the passive mode is not desired, then the automatic door lock in passive mode can be deleted by switching dip switch #3 in the main unit to OFF. Consult your dealer. 2. MANUAL ARMING 1.
Each time the RF-501 is disarmed domelights will turn on for 60 seconds. Entering the vehicle after disarming, and switching on the ignition will turn the dome lights off before the 60 second time limit has expired. NOTE: If the domelight supervision installation procedure (Section F, Page 15) is not installed as shown, then the ignition control door lock system may not work properly in your vehicle. In addition, the 60 second automatic rearm feature will not cancel by opening a door. I.
instantly, and the lights will flash. 2. If optional glass, shock or motion sensors have been installed, rearm the RF-501 and test according to the directions of the particular sensor installed. If triggered in the armed condition, the RF-501 will sound its siren and flash the lights for 60 seconds; then it will stop and automatically reset and rearm. If the violation continues, the alarm will sound and lights will flash for a maximum of two 60 second cycles. L.
security feature. If any transmitter is lost or stolen, enter the programming mode and re-program existing transmitters. Transmitters can only be programmed by entering the programming mode. Existing codes will remain in memory if power to the RF-501 is disconnected. To program the RF-501 transmitters, follow the directions as written below, IN THEIR EXACT ORDER! 1. Flip the VALET/OVERRIDE switch to "ON" position. 2. Turn the ignition switch to "ON", then "OFF", then IMMEDIATELY 3.
7. The RF-501 can learn four transmitter codes. If later optional third and forth transmitters are to be programmed, follow sequence 1 through 6 and re-program ALL existing transmitters. N. PROGRAMMING THE REMOTE TRANSMITTER FOR SECOND & THIRD VEHICLES The RF-501 transmitters are capable of controlling separately installed RF-501 or RF-30 alarm systems in two or three vehicles. To code the RF-501 transmitters for two or three vehicles follow the diagrams as shown.
Note: Here, the first transmitter is assumed to be the primary transmitter of VEHICLE #1, and the second transmitter is assumed to be the primary transmitter of VEHICLE #2. TRANSMITTER #1 TRANSMITTER #2 VEHICLE #1 GREEN BUTTON GREEN BUTTON BLACK BUTTON BOTH BUTTONS VEHICLE #2 BLACK BUTTON BOTH BUTTONS GREEN BUTTON GREEN BUTTON 2. TWO VEHICLE OPERATION WITH TRUNK RELEASE FEATURE INSTALLED In this section the trunk release function is assumed to have been installed in VEHICLE #1 only. 1.
Three vehicle operation is accomplished in the same manner as two vehicle operation. Use the chart below to program three vehicles to operate from one transmitter.
AUTOPAGE ALARM ACCESSORIES AP-4000DX Paging System Vehicle security paging was originated by AutoPage over 15 years ago. The "SHADOW" is our latest version providing a full four watts of output power to signal a handsome belt-clip paging receiver indicating your RF-501 has been triggered, even if you cannot hear the siren. RS-31 Perimeter Protection Sensor The RS-31 utilizes microwave technology that emits a protective field within the vehicle interior.
RK-1 Relay Kit A pre-wired relay and socket for interfacing power lock systems with the RF-501, as well as the starter interrupt function. It may also be used with the AP4000DX paging system to raise and power many automatic power antennas. ES6 As an option to the standard single tone siren package, a six tone siren is available at additional cost. XT-501 Extra remote transmitter.
LIMITED LIFETIME WARRANTY PROVISIONS (U.S. and Continental U.S. Only) 1. AutoPage, Inc. WARRANTS that this new unit has been thoroughly inspected and tested at the factory prior to delivery. Your AutoPage equipment is guaranteed for "life" to the original purchaser/user of the equipment under the following conditions: If the product proves defective (according to AutoPage's testing) within the first year, the defective unit may be exchanged or repaired free of charge.
7 AutoPage shall not be liable, under the foregoing WARRANTIES or otherwise, for: Any personal injury of any kind to the purchaser, its employees or agents or anyone else whomsoever resulting directly or indirectly from the use or presence of the equipment or parts; Consequential damages of any kind; Any inability of the purchaser to use the equipment.
This WARRANTY CARD is for your record. However, AutoPage reserves the right to request you to submit t his WARRANTY CARD which must have complete information to receive warranty service. Please keep this card in a secured place.
1815 W. 205th St.
310-618-2002
