User manual

50
Section 4 MC-III™ EXP Flow Analyzer
To select a device from a network of instruments, perform the following:
1. From the Welcome screen, choose File>Cancel Express Connect (Figure 4.6, page 49).
2. Click File>Discover Modbus
®
Slaves.
3. Enter a range of addresses you want to search (Figure 4.8).
4. Enter the baud rate established for network communications.
5. Adjust the time-out setting, if necessary.
6. Click “Search.” The software will scan all addresses specied and display all instruments connected.
7. Click on the appropriate address to connect to a device.
Note: In daisy-chain congurations, verify that each device has a unique slave address.
Figure 4.8—Automatic detection of all connected devices
A user who knows the address of a specic device may also connect to it by clicking File>Connect Device at
Address (Figure 4.9).
Figure 4.9—Slave address selection screen