Specifications

13PK-900 Gateway Option Supplement
L
+++ Listening OFF
KB7B de N7ML (B,C,D,J,L,N,S,?) >
S(end) The Gateway sends UI frames with a destination of “CQ.” The source
field is the user’s callsign with the SSID decremented by one. The
Gateway holds the data characters until the user sends a (RETURN),
whereupon the held data is broadcast.
Error messages to the connected station (user)
Bad An invalid callsign in response to the AMTOR prompt Enter your
callsign. An invalid callsign as one of the arguments in the Connect
command. An invalid argument to the PORT command.
Too many Too many callsigns in the Connect command. Arguments in the Bye,
Disconnect, Jheard, Listen, Nodes or Send commands.
Too long Command longer than 85 characters. PACTOR callsign in Connect
command was longer than 8 characters.
Range PORT command argument not 1 or 2.
Callsign No argument in the Connect command.
What? Unrecognized command.
?VIA Connect command: second argument wasn’t STAY or VIA.
Not during connect
While a connect attempt was in progress, the user issued a Listen, a
Send, or another Connect command or tried to change Ports; the user
must first disconnect.
Already disconnected
The user tried to disconnect when no connect was in progress.
Need MYSelcal
The packet user tried to make an AMTOR connect, but your TNC’s
MYSELCAL wasn’t set.
None heard The JHEARD or Nodes list is empty.
Channel busy
Connect or Send command while there is AMTOR or PACTOR
activity on the channel. Gateway uses synced radio DCD to determine
activity.
Port busy Connect, Listen or Send command on a packet port where all multi-
connect channels are being used. Attempt to use the PORT command
to access a port whose operating mode isn’t packet, AMTOR Standby
or PACTOR Standby. Port 2 user attempt to access AMTOR or