Specifications

________________________________________________________________________________
QWide "n" Default: 7 (Modem 7)
Mode: All Host: WI
________________________________________________________________________________
"n" - Modem number to be selected when WIde shift is selected.
________________________________________________________________________________
QWide sets the PK-900 modem that will be selected when the command WIDE is set
ON. This command is for software compatability with PK-232 host mode
software.
________________________________________________________________________________
Radio "n1/n2" Default: 1/2
Mode: All Host: RA
_________________________________ Parameters: __________________________________
"n1" - 0 or 1 with 0 meaning Radio Port 1 is OFF and 1 meaning it is ON.
"n2" - 0 to 2 with 0 meaning Radio Port 2 is OFF and 2 meaning it is ON.
________________________________________________________________________________
The Radio command allows the user to control whether each of the Radio Ports is
enabled. Sometimes it is desirable to disable one or both of the Radio Ports
when operation on that port is not desired. The RADIO command allows full
control by you over operation of each Port.
The first argument controls Radio Port 1. When the first argument is 0 (zero)
Radio Port 1 is Disabled. When this first argument is a 1, Radio Port 1 is
enabled.
The second argument controls Radio Port 2. When the second argument is 0,
(zero) Radio Port 2 is Disabled. When the second argument is a 2, Radio Port 2
is enabled.
When a Radio Port is disabled, the LCD status for that port will be blank.
________________________________________________________________________________
RAWhdlc ON|OFF Default: OFF
Mode: Packet Host: RW
_________________________________ Parameters: __________________________________
ON - The PK-900 operates in a raw HDLC packet mode when HOST is ON.
OFF - The PK-900 operates in standard AX.25.
________________________________________________________________________________
The RAWHDLC command enables the PK-900 to bypass the AX.25 packet implementation
and communicate directly with the hardware HDLC (Z8530) on Radio Port 1.
HOST mode must be ON to communicate with the PK-900 in the RAW HDLC mode.
Packet Operation on Radio Port 2 is disabled during RAW HDLC operation.
1/93 A-86