Specifications

________________________________________________________________________________
MDigi ON|OFF Default: OFF
Mode: Packet Host: MD
_________________________________ Parameters: __________________________________
ON - I and UI frames having your call sign (MYCALL or MYALIAS) as the next
digipeater in the field are displayed, regardless of connected status.
OFF - Normal monitoring as determined by the monitoring mode commands.
________________________________________________________________________________
MDIGI permits you to display packets when another station uses your station as a
digipeater. If you want to monitor ALL traffic that flows through your packet
station, set MDIGI ON.
You may not want to see all the data passing through your station, especially if
many others use you as a digipeater. In this case set MDIGI OFF (default).
________________________________________________________________________________
MDMon ON|OFF Default: OFF
Mode: AMTOR and Packet/MailDrop Host: Mm
_________________________________ Parameters: __________________________________
ON - Monitor a calling station's activity on your MailDrop.
OFF - Normal monitoring as determined by the monitoring mode commands.
________________________________________________________________________________
Set MDMON to ON to monitor activity on your MailDrop.
MDMON permits you to monitor activity on your AMTOR or packet MailDrop showing
you both sides of the QSO. Packet headers are not shown while a caller is
logged on. When no one is connected to your MailDrop, channel activity is
monitored according to the setting of MONITOR.
Set MDMON OFF to cancel MailDrop monitoring. Note that MailDrop connect and
link status messages will be displayed even with MDMON OFF. These status
messages are important and allow you to see who is connected to your MailDrop.
They can be disabled however with the UBIT 13 command. See the UBIT command for
more information .
________________________________________________________________________________
MDPrompt text Default: (see text)
Mode: Packet/PACTOR MailDrop Host: Mp
_________________________________ Parameters: __________________________________
text - Any combination of characters and spaces up to a maximum of 80 bytes.
________________________________________________________________________________
MDPROMPT is the command line sent to a calling station by your MailDrop in
response to a Send message command. The default text is:
"Subject:/Enter message, ^Z (CTRL-Z) or /EX to end"
Text before the first slash is sent to the user as the subject prompt; text
after the slash is sent as the message text prompt. If there is no slash in the
text, the subject prompt is "Subject:" and the text prompt is from MDPROMPT.
3/93 A-64