Specifications

________________________________________________________________________________
Help Immediate Command
Mode: Command Host: Not Supported
________________________________________________________________________________
While in Command Mode, type the command "H" to read the abbreviated on-line HELP
file. Your monitor displays the following brief list:
Help:
AScii AMtor PAcket
BAudot ARq Connect
MOrse AList Disconn
DISPlay FEc MHeard
CALibrate AChg CStatus
NAvtex SIgnal FAx TDm
ANalog
PACTOr PTConn PTSend PTList
DIRect 2DIRect VOltage
CONVerse Trans
Opmaode Xmit Rcve Lock
RESTART TESET MDCHECK TClear
You can enter Command Mode at any time to list the HELP text.
________________________________________________________________________________
HEReis "n" Default: $02 <CTRL-B>
Mode: Baudot, ASCII, AMTOR and PACTOR Host: HR
_________________________________ Parameters: __________________________________
"n" - Is the hex representation ($01-$7F) of the character that causes the
AAB string to be sent in the middle of transmitted text.
________________________________________________________________________________
If you wish to send your own AAB string for identification during a transmission
simply enter the HEREIS character (default <CTRL-B>). Also see the command AAB.
________________________________________________________________________________
HId ON|OFF/ON|OFF Default: OFF/OFF
Mode: Packet Host: HI
_________________________________ Parameters: __________________________________
ON - Your PK-900 sends HDLC identification as a digipeater.
OFF - Your PK-900 does not send HDLC identification.
________________________________________________________________________________
Set HID ON to force your PK-900 to send an ID packet every 9.5 minutes when
it's being used as a digipeater. Otherwise leave HID OFF (default).
HID is settable for either Radio Port on the PK-900 since it is not likely
both ports will be performing the digipeater function.
This identification consists of a UI-frame with your station identification
(MYCALL) and MYALIAS in the data field. The packet is addressed to "ID".
NOTE: You cannot change the 9.5-minute automatic interval timing.
3/93 A-54