Specifications

________________________________________________________________________________
FSpeed "n" Default: 2 (120)
Mode: FAX Host: FS
_________________________________ Parameters: __________________________________
"n" - 0 to 4 selects the FAX horizontal scan rate from the table below:
________________________________________________________________________________
1: 1 line/Second 60 lines/Minute
2: 2 lines/Second 120 lines/Minute
3: 3 lines/Second 180 lines/Minute
4: 4 lines/Second 240 lines/Minute
0: 1.5 lines/Second 90 lines/Minute
You can tell the scan rate by listening to the signal. Most weather charts are
transmitted at 2 lines/Second (default), or 120 lines/Minute. Some facsimile
photographs and Japanese news is sent at 60 lines/minute.
With wide-carriage printers, the maximum print densities are reduced. Here are
the maximum print densities at various scan speeds and carriage widths:
FSPEED (LPM) Standard carriage Wide carriage
0 90 183 dpi 113 dpi
1 60 275 dpi 169 dpi
2 120 138 dpi 85 dpi
3 180 92 dpi 56 dpi
4 240 69 dpi 42 dpi
________________________________________________________________________________
FUlldup ON|OFF/ON|OFF Default: OFF/OFF
Mode: Packet Host: FU
_________________________________ Parameters: __________________________________
ON - Full duplex mode is ENABLED.
OFF - Full duplex mode is DISABLED.
________________________________________________________________________________
When full-duplex mode is OFF (default), the PK-900 makes use of the DCD (Data
Carrier Detect) signal from its modem to avoid collisions. FULLDUP may be set
independently for each Radio Port.
When full-duplex mode is ON the PK-900 ignores the DCD signal and
acknowledges packets individually.
Full-duplex operation is useful for full-duplex radio operation, such as through
OSCAR satellites. It should not be used unless both your station and the
distant station can operate in full-duplex.
1/93 A-51