Specifications

________________________________________________________________________________
CANPac "n" Default: $19 <CTRL-Y>
Mode: Packet, Command Host: CP
_________________________________ Parameters: __________________________________
"n" - 0 to $7F (0 to 127 decimal) specifies an ASCII character code.
________________________________________________________________________________
The parameter "n" is the ASCII code for the character you want to type in order
to cancel an input packet or to cancel display output from the PK-900.
You can only cancel the packet that is being entered in CONVERSE Mode. When you
cancel a packet, the line is terminated with a <BACKSLASH> and a new line. You
must cancel the packet before typing the send-packet character.
In the COMMAND mode, this character cancels displayed output from the PK-900.
Typing this character once cancels ALL output from the PK-900 to your display.
Typing the cancel-output character again restores normal output.
________________________________________________________________________________
CASedisp "n" Default: 0 (as is)
Mode: Packet Host: CX
_________________________________ Parameters: __________________________________
"n" - 0 to 2 specifies how your PK-900 sends characters to your terminal.
________________________________________________________________________________
CASEDISP allows you to set the case of the characters your PK-900 sends to your
terminal. CASEDISP offers three possible modes:
CASEDISP 0 "As is" - characters are not changed.
CASEDISP 1 "lower" - all characters are displayed in lower case only.
CASEDISP 2 "UPPER" - all characters are displayed in upper case only.
CASEDISP has no effect on your transmitted data.
________________________________________________________________________________
CBell ON|OFF Default: OFF
Mode: Packet, PACTOR and AMTOR Host: CU
_________________________________ Parameters: __________________________________
ON - Three BELL characters <CTRL-G> ($07) are sent to your terminal with
the "*** CONNECTED to or DISCONNECTED from (call sign)" message.
OFF - BELLS are NOT sent with the CONNECTED or DISCONNECTED message.
________________________________________________________________________________
Set CBELL ON if you want to be notified when someone connects to or disconnects
from your station in Packet. Bell characters are also sent when someone
establishes a link to you in AMTOR.
3/93 A-28