Specifications

too many packets outstanding
The message appears if you've typed enough data to fill the outgoing
buffer in either Converse or Transparent Mode. You cannot re-enter
Converse or Transparent until some of the packets have been sent.
WARNING: Beacon too often
This Warning message appears if you have set the BEACON interval timer
to less than 90 (15 minutes) which is too often for busy channels.
WARNING: CHeck/FRack too small
This Warning message appears if you have set the CHECK timer for too
short a time relative to the FRACK timer.
WARNING: RESptime/FRack too large
This Warning message appears if you have set the RESPTIME timer for
too long a time relative to the FRACK timer.
WARNING: TXdelay too short
This Warning message appears if the TXDELAY timer has been set too
short to send at least one complete flag before the start of a packet.
WARNING: AUdelay > TXdelay
This Warning message appears if the AUDELAY timer has been set equal
to or greater than the TXDELAY timer.
A.4.4 Packet Link Status Messages
Link status messages show you the status of AX.25 connections in which
your PK-900 is involved.
*** CONNECTED to: call1 [via call2[,call3...,call9]]
This message appears when your PK-900 switches to the connected
state.
*** Connect request: call1 [via call2[,call3...,call9]]
Your PK-900 has received but not accepted a connect request from a
distant station.
*** DISCONNECTED: (call sign)
Your PK-900 has switched to the disconnected state. This message
may be preceded by a message explaining the reason for the disconnect.
*** Retry count exceeded
*** DISCONNECTED: <call sign>
Your PK-900 has been disconnected because of a retry failure, rather
than a disconnect request from one of the stations.
1/93 A-7