Specifications

Serial port configuration will change on next RESTART
This message means you have changed the terminal baud rate TBAUD,
word-length AWLEN or the PARITY. When you type the RESTART command,
the new baud rate will take affect.
?need MYSelcal or ?need MYIdent
This message will appear if you try to communicate with another AMTOR
station before you have entered a valid SELCALL (MYSELCAL) or MYIDENT.
?not enough memory available
This message appears if you try to change to FAX when the MailDrop is
too full.
A.4.3 Packet Error Messages
In addition to the General Error Messages described above, the
following messages may appear when entering Packet related commands.
?need MYcall
This message appears if you attempt to make a packet Connection but
have not yet entered your callsign in MYCALL.
?not while connected
You attempted to change MYCALL or AX25L2V2 while in a connected state.
?not while disconnected
You tried to set CONPERM while disconnected.
LINK OUT OF ORDER, possible data loss
You are CONPERMed to another packet station but the link has failed.
?VIA
You typed more than one call sign for the CONNECT or UNPROTO commands
without the VIA keyword.
?channel must be 0-9, A-Z
You typed an invalid channel character after the CHSWITCH character.
?different connectees
You tried to CONNECT to more than one station on the same channel.
?already connected (or attempting connection) to that station
You tried to CONNECT to a station to which you're already connected.
1/93 A-6