Service manual

2 Product Specifications
2-2 SAM4S ER-900/SPS-300 SERIES
[ ER-900 PART ]
Specifications are correct at the time of printing.
Product specifications are subject to change without notice. See below for product specifications.
2-1 General Specifications
Item Description Remark
Processor
• LPC2470 (NXP)
Memory
• PGM : FLASH 16Mbits
• DATA : SRAM 4Mbits
[option : 12Mbits => Total : 16Mbits]
4Mb or 16Mb selectable
Battery
• Type : Lithium, 3V 65mAh
• Charging Time : 24 Hours
• Life : 3 Years
Data Storage
• 90 Days
When battery is Full
charged
Interface Serial
(RS-232C)
• Flow Control :
① DTR / DSR : H/W Flow Control
② XON / XOFF : S/W Flow Control
• Baud Rate : 1200/2400/9600/19200/38400/57600/115200 Bps
• Voltage Supply : VCC(+5V/1A) supplies at RS-232C#1~#4
RS-232C #1(DSUB-9)
RS-232C #2(DSUB-9)
RS-232C #3(RJ45)
RS-232C #4(RJ45)
[Option]: RS-232C #3,#4
SD CARD
• 1-Slot [option]
MSR
• 1-Slot [option]
DRAWER
• 2-PORT [Default (internal) #1 / Option(RJ-11) #2]
i-BUTTON/Addmat
• Magnetic [Option]
USB
• 1-Port [Device, Option]
Printer
• Model : LTPD245/CAPD245 (SII)
• Printing Speed : 85mm / Sec
Detail Spec refer to Next
Page
Auto Cutter
• Type : Guillotine
• Cutting Method : 1 Point Partial Cutting
OPTION
Display
• Operator Display : 2Line 16-Char LCD
• Customer Display : ‘9’ Digits LED
Key Board
• Flat Rubber Key : 150 Key
• Raised Key : 91Key(98key:Option) / 63Key
Power Consumption
• Approx. 33W (Peak)
Power Requirement
• AC 120V/60Hz, AC 230V/50Hz
Environment
Condition
• Temperature : 0℃ ~ 45℃
• humidity : 30% ~ 80% RH
Weight
• Approximately 12Kg (Net), with G-Drawer
Dimensions(mm)
• 400(W) × 450(L) × 300(H) : With G-Drawer
Set Size
Table2-2 General Specifications(ER-900)