Service manual

3 Installation and Operation
3-8 SAM4S ER-900/SPS-300 SERIES
3-3 Installation
3-3-5 Installation of MSR Assembly
3. Connect Ground Wire & MSR Harness of MSR Assembly to the main set as shown in Figure 3-7-○
1
-○
a
.
4. Tidy up the connectors of Ground Wire & MSR Harness by inserting them into the MSR Assembly
(Connectors should be hidden inside the MSR Assembly), Figure 3-7-○
1
-○
b
.
5. Insert MSR Assembly into the main set bracket holes as in Figure 3-7-○
2
, Figure 3-5-○
3
.
6. Tighten MSR Assembly by moving it to the direction shown in Figure 3-7-○
4
.
Figure 3-7 MSR Installation (2)