Service manual

3 Installation and Operation
SAM4S ER-900/SPS-300 SERIES 3-3
3-3 Installation
3-3-1 Paper Roll Installation (1-Station)
1. Remove the cover printer.(Fig 3-2(A))
2. Push up the green lever toward and then lift up to open the paper cover. (Fig 3-2(B))
3. Ensure that the paper is being fed from the bottom of the roll. (Fig 3-2(C))
4. Close the paper cover slowly until it locks firmly.(Fig 3-2(D))
5. Passing the leading edge of the paper through the cutter slot. Tear off the excess paper.(Fig 3-2(E))
Figure 3-2 Paper Installation (1-Station)