Service manual

5-1
Parts Code
J-6080-058-A
J-6080-808-A
J-6080-818-A
J-6082-200-A
J-6020-250-A
J-6082-053-B
J-6080-875-A
J-6082-311-A
J-6082-382-A
J-6082-223-A
J-6082-312-A
J-6080-621-A
J-6082-357-A
J-6082-383-A
J-6082-439-A
Name
Filter for color temperature correction
(C14)
ND filter 1.0
ND filter 0.3
Pattern box PTB-450
Color bar chart for pattern box
Adjusting remote commander
(RM-95-remodeled partly) (Note 1)
Siemens star
Multi CPC jig
CPC-7 jig
Power code (Note 2)
AFM DEV jig
Clear chart
Extension cable (16P, 0.5 mm)
IR receiver jig
Extension cable (70P, 0.8 mm)
Ref. No.
J-1
J-2
J-3
J-4
J-5
J-6
J-7
J-8
J-9
J-10
J-11
J-12
J-13
J-14
Note 1: If the micro processor IC in the adjusting remote
commander is not the new micro processor (UPD7503G-
C56-12), the pages cannot be switched. In this case, replace
with the new micro processor (8-759-148-35).
SECTION 5
ADJUSTMENTS
Refer to page 3 as Table for distinction
functions of models and classification
5-1. CAMERA SECTION ADJUSTMENTS
1-1. PREPARATIONS BEFORE ADJUSTMENT
(CAMERA SECTION)
1-1-1. List of Service Tools
• Oscilloscope
• Adjusting driver
Usage
Auto white balance adjustment/check
White balance adjustment/check
White balance check
White balance check
For checking the flange back
For adjusting LCD block
For adjusting the video section and color viewfinder adjustment
For connecting the battery terminal and DC power supply
For adjusting the deviation
For extension between the CD-210/211 board (CN401) and
VC-215 board (CN501)
For adjusting the IR transmitter
For extension between the DD-107 board (CN931) and
VC-215 board (CN915)
• Color monitor
• Regulated power supply
• Vectorscope
• Digital voltmeter
Note 2: Connect the adjusting remote commander to the LANC
jack, and set the HOLD switch to the “ADJ” side, or press
the battery switch of the battery terminal using adhesive
tape, etc.
Fig. 5-1-1.
J-1 J-2
J-3
J-4 J-5
J-7J-6 J-8 J-9 J-10
J-11 J-12
J-13
J-14
CCD-TR315/TR416/TR416PK/TR516/TR516PK/TR716
CCD-TRV16/TRV16PK/TRV36/TRV36PK/TRV43/TRV46/TRV46PK