Instruction manual

Chapter 4 Menu Settings 4-41
Chapter 4 Menu Settings
4-4-7 TELE FILE Menu
The TELE FILE menu screen is different in HDCAM-
SR and HDCAM formats.
In HDCAM-SR format: The cassette has a memory
label attached as standard, and this screen allows
operations to read out, enter, or change the
cassette ID identification, recording format,
recording information, management information,
and so on. In the HDCAM-SR format, each
recording automatically adds recording
information. However, if the recording time is less
than 2 seconds, or if when recording ends the
measurement on the spool was not complete, then
no recording information is added. In the case of
an HDCAM-SR cassette, a cassette without a
memory label is ejected.
In HDCAM format: When an MLB-1M-100
memory label (optional) is attached to the cassette,
this screen allows operations to read out, enter, or
change the cue point information, log (IN/OUT
point) information, management information, and
so on. Using this information, cassette tape
management and tape editing efficiency can be
improved.
HDCAM-SR format TELE FILE menu
To open the TELE FILE menu
There are two methods of accessing the TELE FILE
menu screen, as follows.
• Press the [F4] (TELE FILE) button while in the CUE
menu.
• Select “on” for the VTR SETUP menu item 124
“Tele-File MENU auto popup”. Then, with the
HOME, TC, VIDEO, AUDIO, CUE, or SETUP
menu open, insert a cassette into the VTR.
To change the information displayed in the
TELE FILE menu
Press the cursor T or t button.
Exiting the TELE FILE menu
Press the [F10] (WRITE/EXIT) button. The entered or
modified data is saved to the memory label and the
VTR exits the TELE FILE menu.
Note
While the data is being changed, if the write-protect
setting has been made for the whole TELE FILE
menu, then data changed before the setting was made
is rewritten.
To exit the TELE FILE menu without saving
data to a memory label
Press the EJECT button, or press the ALT/[F2]
(UNDO ALL) buttons. After a window that confirms
cancelation is displayed, hold down the SFT button,
and press the [F2] (UNDO ALL) button. The memory
label contents when the cassette was inserted are
restored.