Instruction manual

4-4 CUE Menu
4-40 Chapter 4 Menu Settings
Chapter 4 Menu Settings
4-4-6 Backspace Editing
You can perform backspace editing with the CUE
menu. In backspace editing, assemble editing is
performed from the recording end point. Thus, before
starting backspace editing for the first time, you must
record for at least one minute or so on the tape before
you can do backspace editing. After recording, the
present end of the recorded portion becomes the
recording end point. When you press the AUTO
button and then press the REC/EDIT button, the VTR
automatically prerolls a few seconds before the
recording end point and starts assemble editing. If no
data for the recording end point exist, backspace
editing is not performed.
The recording end point will be cleared when you
eject the tape.
Note
Cue point data is cleared when a cassette is inserted.
However, cue point data recalled from a memory stick
before a cassette is inserted is not cleared when a
cassette is inserted.
4-4-5 Changing a Cue Point Into
an Edit Point
Follow the procedures below to change a selected cue
point into an edit point.
To change an edit point into an IN point
Press the SET button while hoding down the IN
button.
To change an edit point into an OUT point
Press the SET button while holding down the OUT
button.
To change an edit point into an AUDIO IN
point
Press the SET button while holding down the AUDIO
IN button.
To change an edit point into an AUDIO OUT
point
Press the SET button while holding down the AUDIO
OUT button.
AUDIO OUT button
SET button
AUDIO IN button
OUT button
IN button