Instruction manual

4-3 TC Menu
4-28 Chapter 4 Menu Settings
Chapter 4 Menu Settings
4-3-6 Selecting the Content of
the Second Time Code Display
Area (TC2 SEL)
Select the content of the second time code display area
using the [F10] (TC2 SEL) button.
Setting Time data displayed
OFF No display
LTC LTC value read from the time code reader
Auto When the playback speed is within the range
±1/2 normal speed, then VITC, and if outside this
range then the LTC is displayed.
VITC VITC value read from the time code reader
CTL CTL signal count value
UBR User bits read by the time code reader (LTC)
UBV User bit value read from the time code reader
(VITC)
TCG Value generated by the time code generator
UBG User bits value generated by the time code
generator
When the two-unit editing display, a warning, or
similar is shown, the second time code display area
does not appear.
For details about the warnings, see “Warning Messages”
on page A-6.
4-3-7 Selecting CTL Display
Mode (TAPE TIMER)
Press the ALT/[F1] (TAPE TIMER) buttons to select a
12-hour or 24-hour clock for the CTL display.
+ –12H: 12-hour clock
24H: 24-hour clock
4-3-8 Presetting Pulldown Time
Code (PDPSET MENU)
(when HKSR-5001 is installed)
To preset the pulldown time code when this VTR is
operated in 23.98PsF/24PsF mode, use the following
procedure.
1 Press the TC button, then press the ALT button.
You can also press the ALT and TC buttons
simultaneously.
2 Press the [F2] (PDPSET MENU) button.
The PDPSET menu appears.
3 Press the [F1] (PRESET MODE) button to select
24F or 30F time code to be preset.
The selected time code is framed with the thick
line.
Each press of the button switches time code
between 24F and 30F.
24F: Presets the 24 frames time code. The A
frame of the pulldown sequence is preset.
30F: Presets the 30 frames time code. The A
frame of the pulldown sequence is preset.
2
543
1
PRESET
MODE
24F
DF F2
PDTIME
SET
EXIT
PD TC
DF/NDF
NDF
INTRP DF 2FO
00H 00M 00S 00F
00H 00M 00S 00F
24F
30F
INTRP