Instruction manual

Appendix A-35
Appendix
Item number Item FunctionSetting
742
CHROMA PHASE
(HD/UC/SD/DC)
preset: 0
–127
.
.
.
0
.
.
.
127
Adjusts the chroma phase (HUE) of HD, UC, SD, and DC output.
755 MASTER LEVEL
(D1)
preset: 100%
(4000H)
0.0% (0H)
.
.
.
100 % (4000H)
.
.
.
141.3% (5A70H)
Adjusts the level of the high D1 video signal output from SD SDI
OUT and FORMAT CONV. OUT (OPTION) connectors.
Simultaneously adjusts the Y, B–Y, and R–Y level.
756
Y LEVEL (D1)
preset: 100%
(4000H)
0.0% (0H)
.
.
.
100 % (4000H)
.
.
.
141.3% (5A70H)
Adjusts the level of the D1 video signal output from SD SDI OUT
and FORMAT CONV. OUT (OPTION) connectors.
Simultaneously adjusts the Y levels.
757
B–Y LEVEL (D1)
preset: 100%
(4000H)
0.0% (0H)
.
.
.
100 % (4000H)
.
.
.
141.3% (5A70H)
Adjusts the level of the D1 video signal output from SD SDI OUT
and FORMAT CONV. OUT (OPTION) connectors. Adjusts the
B–Y level of the video signal.
762 SETUP LEVEL
(CST)
preset: 7.5 IRE
0.0
.
.
.
[7.5]
.
.
.
10.0
Adjusts the setup level of the analog composite video signal
output from SD OUT COMPOSITE (MONITOR) connector.
763 SYNC PHASE (SD)
preset: 0
–128
.
.
.
[0]
.
.
.
127
Adjusts the sync phase of the D1 video signal output from SD
SDI OUT and FORMAT CONV. OUT (OPTION) connectors and
analog composite video signal output from SD OUT
COMPOSITE (MONITOR) connector.
764 FINE (SD)
preset: 0
Makes fine adjustments to the sync phase of the D1 video signal
output from SD SDI OUT and FORMAT CONV. OUT (OPTION)
connectors and analog composite video signal output from SD
OUT COMPOSITE (MONITOR) connector.
[0]
.
.
.
1024
775 VIDEO OUTPUT
DATA
8bit
[10bit]
Sets the bit size of the output data from the HD-SD converter.
8bit: When connected to an 8-bit system
10bit: When connected to a 10-bit system
Notes
• Make sure the bit length matches the destination device.
• This setting is only active when the HD-SD converter output is
set to D1.
(Continued)
776 DOWNCONVERTER
INPUT CHECK
ENABLE
[disable]
enable
Selects the HD-SD converter mode when the INPUT CHECK
button on the control panel is pressed.
disable: The INPUT CHECK button is not linked to HD-SD
converter output.
enable: The INPUT CHECK button is linked to HD-SD converter
output.
Note
The INPUT CHECK button works for all of the HD-SD converter
output connectors.
758 R–Y LEVEL (D1)
preset: 100%
(4000H)
0.0% (0H)
.
.
.
100 % (4000H)
.
.
.
141.3% (5A70H)
Adjusts the level of the D1 video signal output from SD SDI OUT
and FORMAT CONV. OUT (OPTION) connectors. Adjusts the
R–Y level of the video signal.