Instruction manual
6-1 Basic Automatic Editing
6-8 Chapter 6 Editing
Chapter 6 Editing
2 Hold down any two IN, OUT, AUDIO IN, or
AUDIO OUT buttons.
The duration between the points corresponding to
the two buttons is displayed. The value can be
negative.
6-1-7 Cuing Up and Prerolling
You can preroll the tape to a point prior to the edit start
point, or cue up the tape to any edit point.
Follow the procedure below to cue up or preroll the
tape.
1 Press the RECORDER or PLAYER button to
select the VTR which you want to operate.
The button lights up.
2 To cue up the tape to an edit point
Press one of the IN, OUT, AUDIO IN, or AUDIO
OUT button while holding down the PREROLL
button.
The tape moves to the edit point corresponding to
the button, then stops.
Duration
between two
edit points
TIMER
SEL
TC
DUR
DF
PLAY LOCK
TIMER
RESET
TIMER
SET
TIMER
HOLD
off
TCR
SEL
VITC
TCG
MODE
prst
RUN
MODE
rec
DF/NDF
df
TC2
SEL
REGENE
SOURCE
int
0H 01M 00S 00F
AIN 00:01:10:00 AOUT 00:02:10:00
IN 00:01:10:00 OUT 00:02:10:00
2
1
To preroll the tape
Press the PREROLL button.
The tape is rewound to a point before the edit start
point by the amount determined by the preroll time
setting.
Note
When the [F1] (TIMER SEL) button in the TC menu is
set to CTL mode, cuing up is slightly slower than in
TC mode. This is to maintain the accuracy of the CTL
signals.
You can set up the VTR so that priority is placed on
cuing accuracy or speed. Change the setting of the
VTR SETUP menu item 403 “CUEUP BY TC” and
menu item 404 “CUEUP BY CTL”.
Changing the preroll time
The preroll time is factory set to 5 seconds, but can be
set to any time between 0 and 30 seconds, in 1-second
steps.
For details, see “4-2-6 Setting the Preroll Time (PREROLL
TIME)” on page 4-18.
When changing the preroll time, set it so that the
recorded section prior to the edit start point is longer
than the preroll time.
The preroll time used in automatic editing is the preroll
time set for the recorder.