Owner's Manual

DAMAGED, NON-STANDARD, OR IMPROPERLY ASSEMBLED

MAGAZINES SHOULD NEVER BE USED. THEY CAN CAUSE

A MALFUNCTION, SERIOUS INJURY OR DEATH.

STICK MAGAZINE INSPECTION AND CARE

Check your stick magazine frequently to

insure it is in proper working condition. The

follower must move freely and have adequate

spring tension so that each cartridge is

quickly lifted to the feeding position.

To check the spring tension, load one

cartridge into the magazine and then firmly

press against the cartridge case. Remove

your finger quickly. The cartridge should

instantly and fully move into the feeding

position. If it does not, the magazine should

be cleaned. If cleaning does not restore

proper spring tension do not use the

magazine.

Should cleaning be necessary use a high

quality gun cleaning solution that will

not rust the metal. The magazine may be

disassembled by placing a small flat-blade

screwdriver into the slot in the magazine

baseplate and carefully lifting the tab to

clear the magazine tube. Next carefully use

the screwdriver blade to start sliding the

magazine baseplate off the tube by inserting

the blade between the baseplate and front

of the magazine tube. After the initial gap is

opened up between the baseplate and the

tube you can use your thumbs to complete

sliding the baseplate clear of the tube.

CAUTION: The magazine spring is under

tension and could come out causing injury.

To reassemble insert the magazine follower and spring. The spring is uni-

directional and can be installed either way in the magazine tube. While

compressing the spring into the tube slide the magazine baseplate on from the

rear. Finally insert the screwdriver blade into the tab and bend the tab down so

it is flush with the rear of the magazine tube.

MAGAZINE

BASE PL ATE

Tab

Slot

Follower

Tube

Spring