Manual

Loading the Magazine

Use only factory loaded ammunition of the

proper caliber manufactured to US Industry

and SAAMI specifications, referenced by

markings on barrel. (See Notice and

Warnings on page 4 of this manual pertain-

ing to Ammunition).

Examine the recommended ammunition, par-

ticularly on and around the primer. Look for

dents, scratches, and other signs of damage.

Do not load damaged ammunition.

To release the empty magazine from the

frame, hold your hand under the magazine

and push the magazine catch which is locat-

ed on the left side of the frame behind the

trigger. This will cause the magazine to fall

free of the magazine well. (See picture #4)

To load the magazine, place the round at the top (open end), push down and back

making sure that the back of the cartridge is facing the rear of the magazine.

Repeat until magazine is loaded, but do not exceed its capacity. For magazine

capacity, see page 2 under Specifications.

TO MINIMIZE RISK OF UNINTENTIONAL DISCHARGE, LOAD LIVE

AMMUNITION INTO PISTOL ONLY WHEN YOU ARE READY TO

SHOOT.

DAMAGED, NON-STANDARD, OR IMPROPERLY ASSEMBLED

MAGAZINES SHOULD NEVER BE USED. THEY CAN CAUSE A

MALFUNCTION, SERIOUS INJURY OR DEATH.

LEAD EXPOSURE

Discharging firearms in poorly ventilated areas, cleaning firearms, or

handling ammunition may result in exposure to lead and other

substances known to the state of California to cause birth defect,

reproductive harm, and other serious physical injury. Have adequate ventilation at

all times. Wash hands thoroughly after exposure.

PICTURE #4

Magazine

catch

Serrated finger

grips

Magazine

well

Magazine

Retaining lip

Magazine

follower