User Manual

INSTALLATION INSTRUCTIONS
Elite Street Tach
2650-1455-00
Wiring
The wires are connected as follows:
• Black-Negative(ground)batteryconnection.
• Red-Switchedpowerfromthebattery.
• Green-Ignitionsignal(conguredfor4-pulseperrev).
• White-12VoltDashLighting.
Mounting
Pedestal
In-Dash
1)Loosenbothboltsholdingtheshockstraptothemountingfoot.Backboth
boltsoutuntileachisonlyoneortwoturnsintothespacer.
2)Passtachwiresthroughshockstrapassemblyandslidetachcasinginto
shockstrapassembly.
3)Adjusttachandmountingbasetodesiredpositionandtightenbolts
holdingmountingfoottoshockstraptosecuretheassembly.
4)Thespecialdesignofthetachometerbaseallowsforavarietyof
mountingpossibilities.Attachthebaseusingscrewsprovidedorusea
poprivettool.
* Seeautometer.com/tech_installation.aspxforspecic
 vehicleinformation.
WARNING
Warrantywillbevoidifconnectedtocoilwhenusinganaftermarketignitionbox
suchas,butnotlimitedtoproductsfromthefollowingmanufacturers:MSD,Crane,
Jacobs,Mallory,Holley,Etc..Priortoinstallationofyourtachometer,checkwiththe
ignitionboxmanufacturerforrecommendedtachometersignallocation.
*
CAUTION!!!
AsasafetyprecautiontheREDwire of thisproductshouldbefusedbefore
connectingittothepositive(+)sideofswitchedpowersource.Werecommend
usinga4Amp,3AGfast-actingtypecartridgefuse(Littlefuse®#312004or
an equivalent) inline with the RED wire of our product for tachs that use a
Shift-Lite. FortachswithoutaShift-Litewerecommendusinga1Amp3 AG
fast-actingtypecartridgefuse(Littlefuse®#312001oranequivalent).
12V BATTERY
(-)
(+)
* See “Warning” below
(See caution
below)
Good Engine
Ground
Ignition
Switch
Dash
Lighting
Knob
Green
or
Black
Fuse
Red
White
1.Mounttachometerina3
3
/
8
"dia.hole.Becarefulnottocutthehole
toolarge.
2.Cut
3
/
8
"dia.holeinthefirewallforthetachometerwires.Place
arubbergrommetintheholeandroutethewiresthroughthe
grommettotheenginecompartment.
3.Connectthetachometerwiresasshowninthewiringsections.
4.Securethetachometertothedashboardusingtheprovidedbracket
andhardware.
2
1
/
8
"
3¾"
3
11
/
32
"