Installation Manual

Probe Installation
1. Disconnect the negative (-) battery cable.
2. The 2
5
⁄8” gauges may be mounted in a 2
5
⁄8” diameter hole.
The 2
1
⁄16” gauges may be mounted in a 2
1
⁄16” diameter hole.
The hole may be either a hole in the dash, a gauge panel or
an Auto Meter Gauge Pod. (It is best to connect all wiring to
the gauge before mounting it into the gauge hole.)
3. Install light in back of gauge and connect white wire to dash
lighting circuit or to any 12-volt source. Connect BLACK
light socket wire to good ground. Connect RED gauge wire
to switched 12V source. Connect BLACK gauge wire to an
ENGINE GROUND.
4. Verify that all wire connections are correct and secure. Secure
gauge in hole with mounting bracket supplied.
5. Reconnect the negative (-) battery cable.
Red
Red
Black
Yellow
Fuse
(see
caution)
Good
Engine
Ground
+ 12V
Connection
Grommet
Ground
Firewall
White
Black
To Dash
Lghting
12V
12 MONTH LIMITED WARRANTY
Auto Meter Products, Inc. warrants to the consumer that all Auto Meter High Performance products will be free from defects in material and workmanship for a period of twelve (12) months from date of the
original purchase. Products that fail within this 12 month warranty period will be repaired or replaced at Auto Meter’s option to the consumer, when it is determined by Auto Meter Products, Inc. that the product
failed due to defects in material or workmanship. This warranty is limited to the repair or replacement of parts in the Auto Meter instruments. In no event shall this warranty exceed the original purchase price of
the Auto Meter instruments nor shall Auto Meter Products, Inc. be responsible for special, incidental or consequential damages or costs incurred due to the failure of this product. Warranty claims to Auto Meter
must be transportation prepaid and accompanied with dated proof of purchase. This warranty applies only to the original purchaser of product and is non-transferable. All implied warranties shall be limited in
duration to the said 12 month warranty period. Breaking the instrument seal, improper use or installation, accident, water damage, abuse, unauthorized repairs or alterations voids this warranty. Auto Meter
Products, Inc. disclaims any liability for consequential damages due to breach of any written or implied warranty on all products manufactured by Auto Meter.
SERVICE
For service send your product to Auto Meter in a well packed shipping carton. Please include a note explaining what the problem is along with your phone number. If you are sending product
back for Warranty adjustment, you must include a copy (or original) of your sales receipt from the place of purchase.
2650-1726-00 8/7/13
FOR SERVICE SEND TO: AUTO METER PRODUCTS, INC. 413 W. Elm St., Sycamore, IL 60178 USA [phone]
Email us at [e-mail]
http://www.autometer.com
© 2013 Auto Meter Products, Inc.
The Super Bezel is a registered trademark of Auto Meter Products, Inc.
CAUTION!
As a safety precaution, the
+12V terminal of this product
should be fused before
connecting to the 12V ignition
switch. We recommend using a
3 Amp, automotive type fuse.