Installation guide

© 2007 Directed Electronics—all rights reserved 27
auto learn transmitter configuration
button one Car Locator
RemoteStart/Unlock during start
Remote Start
CHANNEL NUMBER FUNCTION
1 Auto Learn
8 Delete all transmitters
3. Transmit. While HOLDING the
Program switch, press the button on the transmitter.
4. Release. Once the code is learned, the Program switch can be released.
You can advance from programming one channel to another by releasing the Program switch and tapping it to
advance steps and then holding it. For instance: You have programmed Channel One and you want to program
Channel Eight. Release the Program switch. Press it 7 times and release it to advance from Channel One to
Channel Eight. Now, press and HOLD the Program switch. The LED will flash eight times. As before, do not release
it. Now press the button on the remote. Programming is now completed.
Learn Routine will be exited if:
■ Ignition is turned off.
■ Program switch is pressed too many times.
■ More than 25 seconds elapses between programming steps.