Service manual

3. DIAGNOSTIC CHECK
3.18 Service Manual BSM-4100
MEMORY CARD Check
This item checks the inserted PCMCIA card and its interface. There are two
checks. The ATTRIBUTE CHECK displays the dump list of attribute area which is
in the PCMCIA card. The COMMON CHECK is the write/read check for common
area. This check continues until you touch the “STOP” key or “RETURN” key.
The check method is the same as the system RAM check.
If the PCMCIA card is not inserted, the program displays the CARD NOT
INSERTED message on the screen.
If an error is detected, the PCMCIA card or MAIN board will be faulty.
Procedure to Start MEMORY CARD Check Program
1. To select the MEMORY CARD Check, touch the “MEMORY CARD CHECK”
key.
2. To display the dump list of attribute area which is in the memory card, touch
the “ATTRIBUTE CHECK” key.
3. To start the common check, touch the “COMMON CHECK” key.
If the check program finds an error, it displays the address, write data and read
data as shown in the above table.
4. To stop the check temporarily, touch the “STOP” key. The “START” key name
changes to normal and the “STOP” key is highlighted.
To continue the check, touch the “START” key again.
5. To return to the MANAUL CHECK MENU screen, touch the “RETURN” key.