Service manual

8. REPLACEABLE PARTS LIST
8.6 Service Manual BSM-4100
Index NK Code No. Qty Description
73 6113-023844D 1 Pump holder
74 6113-037713A 1 Manifold tube
75 6114-073618 1 Sponge
76 1124-037173B 1 High voltage warning label
77 6122-004625A 1 Operation panel sheet
78-a 6123-011918A 1 Input panel for BSM-4103/4113
78-b 6123-011927A 1 Input panel for BSM-4101/4111
79 6143-010267A 1 Shield sheet for BSM-41x1/41x3
80 6112-013857B 1 Recorder blank panel
81 1 BSM-4101A model number label
6124-031984 1 BSM-4101J model number label
6124-031583 1 BSM-4101K model number label
6124-031565 1 BSM-4103A model number label
6124-032002 1 BSM-4103J model number label
6124-031609 1 BSM-4103K model number label
1 BSM-4111A model number label
6124-032029 1 BSM-4111J model number label
6124-031707 1 BSM-4111K model number label
6124-031681 1 BSM-4113A model number label
6124-032047 1 BSM-4113J model number label
6124-031725 1 BSM-4113Kmodel number label
85 915627 1 Gasket (for monitors with revision number CA or later)
86 6114-134909 2 Dust protector (2-S)*
6
A UR-35431 1 Operation board
B UR-3544 1 Function dial board
C UR-35421 1 Power SW board
D 576556A 1 Alarm indicator board
E 575833A 1 Touch screen*
5
F 575815A 1 LCD unit*
6
(for monitors with revision number before CA)
or 916359 1 LCD unit*
6
(for monitors with revision number CA or later)
G UR-3541 1 Connection board
H UR-3586 1 MAIN board
I 575824A 1 Inverter board
J 575842 1 Speaker
K UR-3546*
7
1 ECG RESP1 board
L UR-3547*
7
1 ECG RESP2 board
M UR-3548*
7
1 ECG RESP3 board
N UR-3561 1 NK SpO
2
board
O UR-3557 1 MP1 board
P UR-3558 1 MP2 board
*
5
For the touch screen (Index E) replacement, the two long and short packings must also be replaced with new ones.
*
6
For the LCD unit (Index F) replacement, the two long and short dust protectors (Index 42, 43 and 86) and shielding tape
(Index 55) must also be replaced with new ones.
*
7
ECG input block repair kit is required when one of the ECG RESP1 board, ECG RESP2 board, ECG RESP3 board and
motherboard has a failure. Refer to “Board Compatibility” in Section10 “Internal Switch Setting and Board
Compatibility”.