Service manual

1. GENERAL
Service Manual BSM-4100 1.3
Transport
••
••
• Use the specified shipment container and packing material to
transport the instrument. If necessary, double pack the instrument.
Also, put the instrument into the shipment container after packing so
that the buffer material does not get inside the instrument.
••
••
• When transporting a board or unit of the instrument, be sure to use a
conductive bag. Never use an aluminum bag when transporting the
power board, power unit or board on which a lithium battery is
mounted. Also, never wrap the board or unit of the instrument with
styrene foam or a plastic bag which generates static electricity.
Handling the instrument
••
••
• Because the outside surface of the instrument is made of resin, it is
easily damaged. When handling the instrument, remove clutter from
around the instrument and be careful not to damage the instrument
or get it dirty.
••
••
• Because most of the boards in the instrument are multilayer boards
with surface mounted electrical devices (SMD), a special tool is
required when removing and soldering the electrical devices. To
avoid damaging other electrical components, do not remove and
solder SMD components yourself.
Measuring and Test Equipment
Maintain the accuracy of the measuring and test equipment by
checking and calibrating it according to the check and calibration
procedures.