Service manual

5. DISASSEMBLY AND ASSEMBLY

Service Manual BSM-4100 5.9

CAUTION in Assembling the Instrument

When you fasten the NIBP Safety board and analog output cable at the

ferrite core with the longer shaft screw, do not leave the analog output

cable on the three ICs (U802, U096 and U097) of the DPU board.

If the analog output cable is long and it has been left on the three ICs,

bind the cable with a cable binder as shown below so that the cable is

not left on the three ICs of the DPU board.

The longer shaft screw secures the NIBP

Safety board and ferrite core which holds

the analog output cable.

The unnecessary part of the analog output

cable is bound by a cable binder.