Service manual

3. DIAGNOSTIC CHECK
Service Manual BSM-4100 3.45
NETWORK CARD Check
This item checks the function of the QI-101P network card and its interface. To
perform this check, the optional QI-101P network card is required.
Procedure to Start the NETWORK CARD Check Program
1. To select the NETWORK CARD Check, touch the “NETWORK CARD
CHECK” key at the COM CHECK column.
The check program recognizes the type of card and displays the attribute data
which is memorized in the card.
If the QI-101P network card is not inserted, the “INSERT NETWORK CARD”
message appears on the screen instead of the above screen example. At that
time, when you insert the network card, a few seconds later, the above screen
appears automatically.
If the check program can read the attribute data at the CARD ATTRIBUTE
correctly and there is no error at the attribute data at COMMON RAM CHECK
BY HOST but the instrument has no communication with the network, the
network cable or hub will be faulty. If an error message appears at one of the
five checks, the network card or MAIN board will be faulty.
2. Touch the “ROM CHECK” key on the screen. The CPU of the network card
checks the program data of the ROM in the CPU using the check sum method
and displays the check result on the following screen.