MEX M6X35 Mex MEX ® 24x ® 6x @ 24X 84x Friendly Tip: Please do not completely tighten the screws during assembly. After all the screws are assembled in place, tighten them together. Remember to wear gloves.
Liz Step 1: Place part 8,P,R as shown in the figure to connect © 1 part L (table top) and part K (lags). ® 4X WAX Step 2: Repeat to install 4 four part K {legs).
Step 3: Install part U on part H first. Then place part N (bolt MBX35), R{gaskets), T(thick plastic Gaskets) as shown in the figure to connect part H and part D.
Step 4: Place part N and R in the 5 locations as shown (4 for connecting Part C and A with 1 for connecting Part C with D). Please be careful not to tighten every hole position, only to 80% tightness. HEX Step b: Repeat the above procedures to assemble the another side.
~~ Step 6: Place part Q and R as shown to fix part E in the middle ® 1x of part A and B. Repeat this action to fix part F,G in the middle ~~ of part A and B as shown. Please tighten them all at once.
Step 10: Repeat for another chair. Please Make sure all screws are fixed tightly before use.
