User's Manual

1312
23
456
SUBTITLE
REPEAT
HEL P
POWER
SAT
FLASHBK
1
AUX
RATIO
SD/HD
VCR
CHAN
CHAN
VOL
VOL
DVD
TV
CODE
SEA RCH
PAGE
PAGE
DATE
SURF
SIGNAL
INPUT
Programming with Code Search
If your product does not respond after you have tried all
the codes for your brand, or if your brand is not listed,
try searching for your code by following these steps.
1. Manually turn on the device (TV, VCR, etc.) to be
controlled.
2. Press and hold the CODE SEARCH button until the
red indicator stays on, then release the CODE
SEARCH button.
3. Press and quickly release the desired mode button
(TV, VCR, etc.). The red indicator blinks off once.
4. Press the CHANNEL UP button repeatedly (up to 300
times) until the device to be controlled changes
channel. The red indicator blinks off with each
button press. If you accidentally overshoot the
code required, press the CHANNEL DOWN button
to backtrack through the library until the device
changes channel. Pressing CHANNEL UP changes
direction to forward again.
5. Press and release MUTE to install the code.
Most users will store VCR codes under the VCR button,
DVD codes under DVD, etc. If (for example) you want to
store a VCR code under DVD, first follow the procedure
for Direct Code Entry (page 12) and press DVD in step 2
of Direct Code Entry, then enter ANY VCR code in step 3
of Direct Code Entry. Then follow the steps above for
Code Search (or Brand Search, next page).
Note: If the device does not have a CHANNEL UP
button, use PLAY (VCR only) or POWER instead. Code
Search starts from the currently stored three digit
number under that mode.
2.
3.
4.
Code Entry, cont.
5.
23
456
789
SUBTIT LEREPEAT
HEL P
POWER
SAT
FLASHBK
1
AUX
RATIO SD/HD
VCR
CHAN
CHAN
VOL
VOL
DV D
TV
CODE
SEA RCH
PAGE
PAGE
DATE
SURF
SIGNAL
INPUT
Direct Code Entry
1. Press and hold the CODE SEARCH button until the
red indicator stays on, then release the CODE
SEARCH button.
2. Press and release the desired mode button (TV, VCR,
etc.). The red indicator blinks, then stays lit.
3. Enter the 3 digit code from the code tables (on
separate sheet). Note: after a valid code entry, the
red indicator turns off. For an invalid code, the red
indicator flashes.
4. With your device on, press CHANNEL UP. If the
device responds, no further programming is
required. Note: If some buttons do not operate your
equipment, try one of the other codes for your
brand.
Code Entry
1.
2.
3.
Write your codes down here for easy reference later.
Type Type stored Code
TV TV
VCR
SAT 363
DVD